Insulating separation connector type ITV
for the electrical isolation or galvanic separation of system parts, corresponds to the requirements to an insulator according to EN 12514-2 and E DIN EN 12514-3:2009
operating media:
- waste oil, fuel oil, heavy fuel oil
- version with FKM O-ring: BTL, diesel, FAME, fuel oil bio and vegetable oil
Article name
for the electrical isolation or galvanic separation of system parts, corresponds to the requirements to an insulator according to EN 12514-2 and E DIN EN 12514-3:2009
operating media:
- waste oil, fuel oil, heavy fuel oil
- version with FKM O-ring: BTL, diesel, FAME, fuel oil bio and vegetable oil
Open all Close all Advantages and equipment Conformity Technical data Product note
- for the electrical isolation of underground tanks with cathodic corrosion protection and grounded system parts
- for the galvanic separation with different pipe materials for the avoidance of contact corrosion
- resistance against exposure to flames according to EN 60335-1 and EN 60695-2-11
- DOC according to MVV TB [administrative regulation on technical construction requirements] C 2.15.23: EN 12514-2
- maximum permissible pressure: PS 16 bar
- material: Steel, PA 6 or PA 6-GF50
For the correct selection and assembly of compression fittings, please refer to the GOK assembly manual and the data sheets for compression fittings and screw-in connectors (at www.gok.de/en/data-sheets or www.gok.de/en/installation-instructions). If you are installing a compression fitting with copper or aluminium pipe, you must use a reinforcement ring. For aluminium pipes, use a reinforcement ring made of steel! All compression fittings are approved by the DVGW.